Characteristics of JJ-3 constant temperature electric mixer:
JJ-3 constant temperature electric mixer with electric stirring and constant temperature heating two kinds of functions. This machine adopts the permanent magnet DC motor, which has the characteristics of increasing force distance, steady speed, low noise and continuous adjustment. The stirring rod is made of stainless steel and is resistant to corrosion, which is suitable for all kinds of laboratory, laboratory and medical machinery for liquid mixing. Such as the mixture of plasma or oil drugs, such as uniform mixing.
Performance of JJ-3 constant temperature electric mixer:
1, power: 50Hz 220V
2, motor: 12V DC
3, speed range: 0-3000 / min
4, time: 5-120 minutes / clock
5, temperature control range: room temperature -200
6, heating power: 1000W
JJ-3 constant temperature electric mixer using manual
The parts are installed, according to the requirements of the motor is high, the motor plug must be in the marked "motor" mark in the hole, and the rest can be inserted into the corresponding operation.
1, press the power switch, the timing will be selected to the time required to stir, and then adjust the speed of mixing.
2, for heating the first press the power switch, then open the heating switch, press the switch on the left will be set, adjust the temperature control knob,
To the required temperature, and then set the switch to the right, the heater begins to heat, the digital temperature sensor is measured by the actual temperature.
Matters needing attention：
1, when in use, such as found in mixing are not concentric, stirring instability phenomenon, please adjust the tight chuck, stir bar together, if you use the flask stirring, the stirring rod at the center, and then start to stir.
2, when suddenly the power is disconnected please check the power supply wire is shedding phenomenon, such as do not belong to the above situation, please inform the factory maintenance.
3 of electricity, security: the product is made of 220V AC power supply, power supply socket should be used three security socket, must be properly grounded.